Discussion Locked

Beyond 4 IDE Devices on Mother Board

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Any thoughts on the best methods/practices for adding more than 4 IDE devices to a system when the Mother board is maxed out? Also, IDE controller products. For example:

1 CD ROM
1 TAPE DRIVE
1 ZIP DRIVE
1 MASTER HARD DRIVE
1 SLAVE HARD DRIVE

3 PCI slots available.
Thanks for the feedback and input.

4 replies

by thechas

Just add a PCI IDE controller card to your system.

I have used the Ultra ATA100 from Promise Technologies with no problems.

Place your hard drive(s) on the controller card, and set your BIOS boot sequence to SCSI.

I would place the CD driveas the Slave on the primary IDE on the motherboard, and the other 2 drives on the Secondary.

Chas

by mtberjim

But don't forget, the more things you run the bigger power supply needs to be.
Good luck, Jim D.

by djent

Consider SCSI as the next move. one interupt for up to 15 devices, concurrent read/write on all devices, up to 320mbps rate, higher quality drives are some of the reasons.

This discussion is closed to new replies.