Question Locked

BIOS woes, where should I go from here?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Here is the scenario. Client comes in with a system with a BIOStar P4M800-M7 that he flashed with the BIOS for a P4M800-Pro M7. All that he gets is the BIOStar screen when it boots. That tells me that he mobo is good, so we get a replacement BIOS chip flashed with the right version of the BIOS (that is an assumption that it is the right one, I have no way of verifying). When I put the new chip in, I get power and POST, but no video. Tried taking out the AGP card and working solely on the on-board card, and have reset the CMOS a couple of times to no avail. Any thoughts? As you may have guessed, I am suspect of the chip, but without anyway to verify one way or the other, I am wondering if I should go another direction.

6 replies

by tig2

Could the on-board vid have gone south? Try reseating the AGP card and reboot. If still naught, I would follow your first instinct. The other thought I have is if you are using a known good monitor to receive that vid signal.

Leave the CMOS alone, I don't think that the problem lies there.

by joshuan

Nothing from the AGP slot either. I know that the monitor is good, it is the same monitor that would show the BIOStar screen with the old BIOS chip. Nothing changed there.

Only reason I reset the CMOS jumper was to reset the mobo to factory spec.

by joshuan

Tried the boot block floppy boot when the bad flash first happened (old chip), and it didn't work. I think it was because there was no floppy in the system, and the floppy wasn't in the opiginal boot sequence. I will try it again, didn't think of that.

EDIT Floppy will not boot. Doesn't even look like it is engaging (no flash or beeps)

by oh smeg

I suppose it's possible that you got a bad one.

But I would be looking at the M'Board being faulty first. That is the more believable option.

Col

This discussion is closed to new replies.