Question Locked

blew my mobo or memory?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I WAS PUTING IN A NEW PCI EXPRESS CARD INTO MY PALVILION A814X AND COULD NOT GET THE CARD TO WORK. I REINSTALLED THE OLD MEMORY AND NOW WHEN THE SYSTEM TRIES TO BOOT, IT GOES THROUGH THE BOOT STEPS BUT THEN RIGHT TO A BLANK SCREEN. ANY IDEAS?

9 replies

by robo_dev

going thru the boot steps...meaning the HP logo, BIOS memory counting, etc?

or the boot steps of 'Windows loading'.....

The first guess would be that you knocked a cable loose, like the power or data connector for the hard drive.

If you blew up the ram or motherboard, you would likely end up with either no POST at all, or a bunch of beep codes.

BTW, don't type all in caps.....

by ---tk---

If you were installing a PCI Express card why did you remove your RAM? or did you upgrade that too?

by jjwex

Yes the windows boot up seems to finish but then it goes black..............no beeps.

by thumbsup2

Why were you trying to install a new card to begin with? Did the old one not work?

According to the specs on the HP web site, this model did not come with a PCI Express slot. So, I'm curious as to why you would be attempting to install one.

by dixon

...you did power down the sytem and pull the power cord before beginning all this surgery, right?

by jjwex

i powered down the system. when i power it up now ..............it keeps trying to boot.....hd running and searching but the screen remains blank and the boot up just goes on

by dixon

Take away everything except motherboard, CPU, PSU, hard drive, original video card, and one stick of RAM. Any luck?

This discussion is closed to new replies.