Discussion Locked

Blue Screen Of DEATH

0 helpful
27 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ok. I'm new to this whole computer thing and am very caucious when it comes to doing anything to possibly harm or cause problems. I am extremely thurough and study everything before I make any kind of programming change. Nevertheless, I've offically locked myself out of my desktop. Allow me to explain:

Error message I receive on startup:

A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is...bla bla bla, follow these steps.
Check for viruses on your computer. Remove any newly installed hard drives or hard drive controlers. Check your hard drive to make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.
Technicial information:
*** STOP: 0x0000007b (0xf96dd528, 0xc0000034, 0x00000000, 0x00000000)

Oddly, my computer did not shut down, I went to restart it in safe mode to remove Smitfraud--a trogan that creates a driver in the \windows\system32\ and runs all the time in the background, pulling up webpages and clogging up CPU. (its really fun):)

Anyway, I figured I'd use this chance while I still have some of my hair left and before I loaded my 357 to put a bullet in this wounded horse to see what you guys thought about that...

27 replies

by torturednacho

First off, Trying to avoid disaster and misconfiguration is a prelude to that 357 your talking about. Its all about trial and error. Make sure your backups are up to date and you are good to go.

On the other Hand.Maybe when I was Programming DOS Eggdrops. I thought viruses and attacks were fun, But its actually just stupid.
I Prefer "Gray Hacker" , ..Figure out the holes and then work with the companies to fix the holes.Viruses are .. Well in a tech word "Lame sauce"
:)

by nepenthe0

I would reformat the HD and do a [i]clean[/i] reinstallation of the operating system. Hopefully you have a data backup.

A number of TR participants have criticized me for this advice, but desperate situations require desperate solutions. I make periodic drive image backups with Norton Ghost, just on the contingency that a scenario such as you describe might confront me.

Norton Ghost rewrites the HD at 1-2GB/min. I'm up and running under 20 minutes when disasters strike. And they do.

Rick/Portland, OR

by boxfiddler Hot topic

please?
For example: KERNEL_STACK_INPAGE_ERROR
or
PAGE_FAULT_IN_NON_PAGED_AREA

That information would help a lot. Also, what OS are you running? Windows? 2K, XP, Vista? These things make a difference.

by porstech

this shouldn't take long.

In the meantime, I tried to use a WindowsXP--cause that's what I have on both my lappy and desk--and tried to use it with no luck. I did make it off of my lappy and it does work like it should, but nothing seems to be working for me. Even tried using the reinstall disc from my lappy, cause I dont have one from my desk, and to no suprise, no progress.

Just got done with that scann. "All tests passed"

by boxfiddler Hot topic

forgot to leave off the parameters. :( Oh well, at least no thumbs are at stake!

etu

by porstech

Tried going there and got sent somewhere else. Been looking around online and very few people have had this problem.

by the scummy one

it may be a HDD controller, or HDD issue would be the most suspect.
If I interpreted another response correctly, you tried booting to an XP disc and it failed? Maybe your HDD is going out.

Best suggestion is to have the drive checked out, or boot to an AV floppy/CD and scan to remove any problems before Win loads.

If it checks out fine, then I would try safe mode -- command prompt and try a system restore.
If that does not work, re-installation may be needed/best. But as suggested, backup your data before doing anything else if you do not have a current backup. If your drive is failing, then getting the data may be at a critical state.

by porstech

Dude, I can't even get into safe mode. DOS loads, Windows nothing. Goes Blue right when it should be loading the Windows logo

by the scummy one

memory address where the stop error occurred. This can often be translated into a specific device if you can find the memory allocated to a device. However it can be problematic if it is in an address assigned to a program when launched or when sitting in virtual memory (Swap file).

If it is HW related, looking over the address and comparing it to installed HW may find the fault. In that case, re-installing the driver or updating it (sometimes downgrading it) can bring positive effects.
However from my interpretation, a boot disk failed as well, which would suggest an actual HW failure or impending failure.
:D

by porstech

Keep in mind, to every problem there is a solution. I know there is a way out of this without the dreaded "reformatting" and all that. The HDD is still functioning. It's
Windows that I'm having a problem with.

Im just Hoping there's a less drastic solution

by porstech

After the stop code there is nothing at all...A big blue square if that helps lol

by porstech

still learing all the "computer shop talk". I'm running a dell inspiron 8200 that I build as my gunipig (however the hell you spell that) and Have had absolutely no problems out of it...all day...lol.

In current news, i typed it just as it appears, save the second paragraph which always sais the same thing whenever the blue screen comes up:

If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps.

Is there a way to "hack" into windows even if it isn't running properly? Thought maby if I could get in, I could f**k it up worse.

by porstech

disk, both start up and reformat, although they were both from my lappy, but both systems are XP. HDD seems to be running like it should but just before it gets to the windows logo is when it goes into "death mode", if that's of any help.

by boxfiddler Hot topic

and there are no strange noises coming from it, I wouldn't think it is the hard drive or the controller (but lack of noise is not necessarily an indicator). It strikes me that your Master Boot Record could be hosed. If you can't repair it using your lappie system disk - which is likely quite specific to your lappie - you need a stand alone copy of XP to do so.

by the scummy one

get into the BIOS and see if there is a HDD error checking tool there. It is not OS specific and the tool is not located on the HDD.
If there is a HDD or controller problem, the test will show at least 1 failure. This should be able to rule out a HW issue with the drive in question.

Also, did you boot to an AV cd/floppy to scan before Win loads? what were the results?

by porstech

How would I beable to find the device or driver assigned to that parameter whithout being able to get into at least safe mode?

I'm also asking if there is a way to hack it without it wirking properly so i can have a chance to fix it. I don't believe it is a hardware problem or it would show when I tested the system for faults...wouldn't it?

by porstech

Completely stock. Got infested with adware and removed all accept smitfraud. This happened on reboot, completely unexpected. Scaned for virsused and other stuff right before restart and it was clean. Computer is a couple years old, but barely used, i.e. only on occasion. Probably needs cleaned out but it was running good.

This discussion is closed to new replies.