5 replies
by westec77
There may be a mis-match between your bios settings and computer hardware. You should manually reset the default bios settings.
or visit www.sacramentocomputertechnician.com
by wauchula
Is the system time correct?
maybe the bios battery is weak.
by blackcurrant
Hi
The answer above seems the most likely solution - replace your motherboard (CMOS) battery, reboot, check the BIOS and everything should be fine. Have you or anyone else also recently used a procedure to bypass the BIOS password? I have seen this message when bypassing password protected BIOS's on some of our work machines.
by blackcurrant
Hello again
I received your message. You say:
"yes i did used that i remove the jumper to clear it yes on my compaq what can i do to get it back to normal though"
What you need to do is to make sure your BIOS correctly identifies your hard drives and to make sure that any other settings are correct.
What you also need to do is make sure that the jumper is replaced in its original position.
You can find more information about what you have done and how to fix it here:
http://www.computerhope.com/issues/ch000235.htm
Good luck
by otl
A little more system information would be helpfull.
Some models used EDO ram and any form of mismatch will cause extremely strange blue screen errors/error codes.
Do you have 2 CD's or did you recently replace the CD ?
Any recent system changes ? Just before you started recieving this error ?
Or possible power problems ? Power outage or circuit breaker trip ?
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending