Question Locked

Booting Bart-PE on a Linux system

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm trying to boot a Red Hat Enterprise box with a Bart-PE CD, with the goal of making a Ghost image of the primary drive onto a network drive.

Bart gets only as far as the initial "Setup is inspecting your computer's configuration.." line, then nothing but blank screen and a constant HD activity light. I've used the same CD for months on other systems, so I don't think it's the problem.

Can a RH box be booted from a Bart-PE CD? Will Ghost (specifically the ghost32 command line tool) be able to "see" the drive?

12 replies

by bens

I too use Bart PE w/ Ghost32 and had no problems booting it up with Linux Mint. I've seen that hang up before, make sure you dont have a floppy in the drive. Could be CDROM/HDD issues, maybe?

by robo_dev

what kind of drives, SATA?

maybe do the F6 load drivers routine for your specific disk controller hardware?

by charliespencer

IDE. I was able to boot this box with Bart when it had XP and Debian. A co-worker at another facility configured it for Red Hat (I couldn't make it do what I needed it to; lack of Linux skills) but neither of us can get it to boot with Bart.

by rob miners

a CMOS Reset by shorting out the jumpers, you may have to refer to the manual to find them.

by charliespencer

Nope. I tried a soft reset first from the BIOS menu, then a hard reset with the jumpers. No difference.

by rob miners

bootable CD. It seems like it can't access the drive.

by jaqui

option to view logs / kernel messages in bart-pe?

I've never even looked at it, so I have no real clue, but a linux sysem that hangs on boot like that the function keys will display different pages of data.
logs
kernel messages. [ very useful when it won't boot because it's using UDMA and the hardware doesn't support UDMA for the device. drive seek failed, drive not ready error messages scrolling in the kernel message screen ]

by charliespencer

It boots from a CD, so it can't write the logs there. It's apparently unable to access the HD, and doesn't write logs there anyway. It may write some to the RAM drive it creates, but it's not getting far enough into the boot process for me to interact with it in any way. Obviously any logs in the RAM are gone when I'm left with no option but to reboot.

by charliespencer

I'm going to put another HD in as the primary and move the RH drive to secondary and see if I can get to it.

Edited - Success. With an XP drive as the primary I can boot. XP-based Bart doesn't show the drive at all in Windows Explorer (as expected). Disk Manager shows it as Active but unformatted. The good part is that Ghost32 sees it as just another drive.

I'm giving myself a "Thumbs Up" for this one.

by rob mekel

there had to be some benifit on getting older ... and look ... week after your birthday ... it pays off :)

Nice work Palmetto

by rob miners

that they can't teach an old dog new tricks. Way to go go Mate.

This discussion is closed to new replies.