Discussion Locked

BOOTP will NOT work on Cisco6509, but works fine on edge devices

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an unusual situation. 90% of our workstations connected to the core 6509 switch fail to optain a BootP, yet any workstation connected to a edge switch, which is directly connected to the same 6509 Core switch,works fine.

I have even plugged a WS directly to the same port the other switch was on, and it does not work. Yet I can take a small dump 5-port switch, ploug it into the 6509, and then a WS to that small switch, and it receives the BootP PERFECTLY. HELP!!

2 replies

by sgt_shultz

I have not experienced your problem but for what its worth I have seen similar weird stuff when the port on the did not sense the speed correctly. can you lock it down or up to 10mb half duplex. can you upgrade the firmware in the

by deepsand

The "Discussion" forum is for matters of general discussion, not specific problems in search of a solution.

Post problems such as this to the "Question" forum, rather than the "Discussion" forum. There are those who specifically seek out problems in need of a solution, and that's where they go to look for such.

Additionally there are the benefits that:

1) The "Questions" forum provides for your feedback, by way of your being able to mark "helpful" responses as such. This does not necessarily mean that a given response contained the complete solution to your problem, but only that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours, so that they might have a ready source of reference available, thereby perhaps obviating the need for them to repeat questions previously asked and answered.

2) The revised TR makes it quite difficult to find both "Discussions" and "Questions" that have not had a fairly recent post, owing to some functions comingling them in the listings. By keeping each type in their respective forums, it is easier for all to find what they are looking for.

This discussion is closed to new replies.