Discussion Locked

Brain Fart - stuck NTS4 disk in NTWS4

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

OK, I screwed up. I tried using an NT Server 4 disk to install Dial-up networking on an NT 4 Workstation.
When I realized my mistake I tried using a NTWS disk but it couldn't read the RASCONF.dll file so I tried another NTWS disk and got the same error. Then I copied the i386 folder to the local hard drive and tried installing DUN from there but as soon as I specify the path to the file, the install windows instantly close. No progress bars, no pop-up saying if the install was successful or failed. Not a thing but just the desktop. (Nothing in Event viewer). When I tried installing from a network drive, the same thing happens as when I was installing it from the local hard drive. I applied SP6 HE and tried it again and the same thing happens.
Any suggestions?
Thanks

3 replies

by Member 23567752

I am certainly not an expert here, but I have fixed a dial up RASMAN networking problem by removing domain from Workstation then all modems. It forces NT to remove bindings etc, and allows you to add networking and DUN when you reinstall modem.

Good luck.

This discussion is closed to new replies.