Discussion Locked

Broadcast in the Network

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi,

i am facing some problem in my network.
it is generating thousands of broadcasts and it is making my network slow. i need to stop them.
what i will have to do?

regards,

chiranjib

2 replies

by deadly ernest

Some device on the network must be sending the broadcast messages for a reason, either administrative problems or a virus. You need to get and use some monitoring software to identify the ports being used and the machine/s doing the broadcasting. Then you need to check those machines for a virus or a trojan and then set them up to work properly without the excessive broadcasts.

One program I use is Active Ports from www.ntutility.com it is a free program that you load onto an individual maCHINE And it tells you what that machine is doing.

A likely problem is two or more machines trying to provide the same service constantly trying to correct the information the network has about who is doing that job. Or you may have too many machines using hubs that are all talking to each other.

Don't know what your hardware knowledge lev el is but, hubs work by broadcasting all transmissions get a lot of machines on hubs, or hubs connected to hubs and every signal gets sent multiple times. Switches and routers direct tranmissions to specific machines, except for a few 'who is there' broadcasts. In any good network you should have it segregated with switches and routers and minimal use of hubs within any one segment.

by gsi_3wg

Good day.

Not much detail in your request...
Let start step by step..

Amongst the questions you should have a look for :
- Topology of your network. (Ethernet ? Soemthing Else)
- Hubs or/and switches ?

- Applications used.
- List of Hosts.

Answering or getting an idea about these questions will help you later.

Broadcast can be caused by a problem or by hackers.

They can be caused by a single host or by many hosts.

Broadcast can be directed to the whole network
ex : An ICMP packet storm.

Or can be directed to a single port (ie apps/service)
ex : a DHCP request.

Broadcast can be local or general

Local broadcast should look like : 192.168.xx.255
General Broadcast will look like 255.255.255.255

Now you need a tool to know better.
Usually the best tool for that is a protocol analyser.

Protocol analyser can be :
- a dedicated boxes (Sniffer Pro) or
- Software
- Windows : EtheReal
- Linux : TCPDump, EtheReal

The best you could do is to download a
BootCD image of a software called Knoppix.

Available at : http://www.knopper.net/knoppix-mirrors/index-en.html

On that CD you will find TCPDump and EtheReal.
Boot with that CD And run either...

With these protocol analysers, you will be able to find the origin of your broadcast storm.

Hope it help...
Oh, and by the way Good Weekend...

This discussion is closed to new replies.