Question Locked

Bypassing a laptop graphic card

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hope someone can help me!

I have a HP ZD8000 series laptop running windows xp. I have just spent out on a new screen to replace a fautly one and a day afterwards the graphics card has given up.Both of these problems appear to be known hardware issues and the graphics card is almost certainly to do with overheating.
Is there any way to run the laptop in full software video mode? On booting the splash screen displays and I have had it running in full view in safe mode so I'm just looking for a way of disabling the graphics card and running the laptop in software video mode (I know it will look rubbish but I just want to get it working again). I shall try it again tomorrow as for some reason it worked for about an hour this evening then gave up again.
I cannot get it to load safe mode now and it hangs with the last dialogue line shown as being...system32\drivers\btkrnl.sys (I'm assuming this is a graphics driver?).
BTW I've tried an external monitor but that shows the same as the laptop display.
Oh and I've also tried the 'Enable VGA Mode' option on the F8 Startup menu. The graphics card does not show as an option in bios.

Thanks in advance

11 replies

by mark

Sorry to bump this guys.
Has anyone got an idea on how I can get this up and running without using the graphics card please?

Sorry to be a pain.

by rahouseholder

You can try booting into safe mode and remove the graphics driver then reboot and load the default vga drivers. There is now way to not use the graphics card....

by cmiller5400

If the graphics card is bad then it must be replaced. There is no way to bypass it with software. You must replace the card or motherboard depending on the maker.

by oh smeg

You're Stuffed completely.

But having said that if these are [b]Known Problems[/b] with this Model have you bothered to look at HP Web Site to see if they have issued a Recall for this Model?

Col

by mark

Yes I've gone through the website and several discussion groups and forums. I've also been in contact with HP tech support and as it is out of warranty they don't want to know unless I'm prepared to spend hundreds of pounds on a motherboard replacement. This range of laptops uses a desktop based processor but has insufficient cooling but HP emphatically denies there is a major issue and anyone that contacts them are told that they are rare occurences. I rectified the screen issue by buying a new screen from ebay at gbp155 instead of the gbp450 ish that the HP recommended suppliers were asking but almost as soon as I did that the graphics card bit the dust.
I only asked because even now, the splash screen and any dos screens etc that I load up (from recovery disks etc) still display it's just when the graphics card kicks in that everything goes black. So I just thought I may be able to use windows with the same software based screen rendering. Thanks for the reply all the same, I won't waste my time if it's not possible.

Cheers

by mark

Having said all of this, I have just clean re-installed windows xp using a different version of the operating system (not the recovery version) due to major problems with the old one and I have now got a display back again. It has not loaded the correct drivers and is not asking for the correct drivers either. I can only run in 1024 x 768 but this is fine for what I want to use it for although I doubt that many games will run like this, but fingers crossed this will get me out of trouble for a while.

Thanks for your help again.

by oh smeg

You'll also most likely find that the Modem isn't working either so you should download the correct drivers for your hardware so that you can get full use out of it.

As HP has a lot of ZD8000 models you'll need to start here with your full Model Number

http://tinyurl.com/2vrpsc

Col

by mark

Cheers Oh Smeg, I'd already got them. The one driver I didn't load was the graphics driver and the laptop is still running fine. I can't run anything that utilises the 3D graphics card but VGA and software rendered stuff is fine.

Thanks again for your help.

by tig2

When using my laptop on a desk or other hard surface at home, I have it sitting on a wire cooling rack- like you will find in the kitchen or cooling cookies from the oven. What it does is raise the lappie about an inch from the surface and allows better air flow and therefore better heat dispersal. It is much cheaper than an Ice Pad and does the same job.

The ones I bought were $5 from the local discount store. The fully accommodate a 17" MacBook Pro; the surface of which is actually quite cool despite several hours of use.

by mark

That's not a bad idea Tigger Two. At the moment I use an overturned food tray with ridges on which raise the laptop slightly. I've ordered a laptop cooling tray which has three fans run from a USB port so that should help as well. It may well be worth me going into overkill with it and also using one of these wire trays as long as it doesn't slide around too much.

Good suggestion.

Cheers

This discussion is closed to new replies.