Windows Forum

Ask something
Discussion Locked

Cable DSL Router

0 helpful
9 replies

by deangk

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to setup a Netgear Gateway Router on my Win2000 Server, I am unable to connect to the Internt with the clients. Help Please

1) Turned off DHCP on the Netgear
2) DHCP is working on Win2000 Server
3) IP Range 192.168.15.1 to 192.168.15.254
4) Excluded range 192.168.15.1 to 192.168.15.10
5) Server IP 192.168.15.2
6) Scope Options I have
044 Wins/NBNC, 046 Wins/Nbt, 003 Router, 006 DNS
Router IP 192.168.1.1
Subnet 255.255.255.0

Any further suggestions

Thanks

9 replies

by grimreality

If you are with the AT&T Broadband goupr of customers then turn DHCP back on on the router and then call in and provision the WAN MAC id of the machine. Once this is done just disconnect the power supply of the modem then router, wait about1 minuteand reconnect modem then router. Renew ip on the pcs and voila.

by ins413

Your router IP doesn't appear to be on the same subnet as the rest of the clients. This may just be a typo in your question. If it isn't, try changing the router IP to 192.168.15.1.

Good Luck.

Norm

by dion1

The Netgear router have to be configured to receive a dynamic Ip address from your ISP, your router must be able perform NAT, configure your Win 2K server interface as internal interface with 192.168. 15.1 ip address and the outside interface of therouter as default gatewayto your win 2k server, turn on DHCP at your Win 2k server,make sure you have a valid DNS address on your Win 2k server DNS tap. Please ask your ISP for the DNS address and also visit netgear website.

Hope this will help you.

by nandaluri

You are using 15.0 network. but your router running on 1.0 network. first change ypur router ip address to 15.0 network. give router address to client gateway ip address. Try it

This discussion is closed to new replies.