Discussion Locked

Cabling and switches in a cube farm

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are moving to a huge one story building which will push the limits of 100M Cat5 and so I am investigating how to install switches close to the cubes and run fiber back to the server room. Has anyone done this? How did you protect the switch? Iam thinking of getting some type of perforated cage for the switch and mount it to the power pole but haven't found a source.
Thanks,
Angela

4 replies

by shiny_topadm

Hi, you should check out "low-profile, wallmount cabinets" for mounting requirements. We have used "Black Box" www.blackbox.com and "MilesTek" www.milestek.com, but I'm sure there are other sources. These can accomodate rack-mount gear vertically or sideways and some even include locking covers and powered ventilation. I would NEVER connect a switch (or similar device) in a user workstation area without taking security, power, and service access issues into account. If the nearest workstation was a sysadmin, etc. I might consider no enclosure, but I would tend toward maximum protection, minimum access (i.e. the switch is an extension of the server-room). Good luck.

by ebob

I would (conceptually) segment the large one floor, then treat each segment the same way I would a multi-story "office tower" facility. Which is pretty much as you describe: Cat5E from the cubes to a central spot in each segment housing a switch, and fibre hauled back to the "computer room".

Your real question seems to be how to secure the switch. Most providers will have lockable cabinets that will do quite nicely. Your cabling contractor can help you. Look for one with good ventilation, solid construction, a built-in rack and room for expansion/growth.

Where to locate it? In the environment you describe there is likely an area in each "segment" where the departmental photocopier and colour laser sit. That would be a good place to start looking.

by jose mir

Do you have to distribute your switches in a big floor? No problem; you can put them in cabinets, with lock and UPS, and it will be 99% secure.
Which Racks? I have uses MilesTek wall mount Rack model 70190 ($ 170) which has enough space to hold theSwitch (I have used 3Com’s ones) and a Rack-mounted UPS.
I also have used APC Smart rack mount UPS PowerStack 250 ($ 250).
About the runs between switches and the server room, if you can use fiber it will be great, but maybe you could make them with cat. 5 (depending on network topology) and save some money.
About the security access, if you use cabinets with lock and mount them high, near the ceiling, you will minimize risk (also, you could use MAC address security options to gain extra isolation).
I almost forget! You will gain stability if you run Isolated Ground outlets (the orange ones) to this switches, even if you use UPSs.

Regards,

Jose P. Mir
jpm@jpmir.net

This discussion is closed to new replies.