Question Locked

Can boot to XP, but only with system disk in.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello Guys i have an issue that not a priority but its getting to be an annoyance.

Everytime i boot up without the system disk in my drive, i receive a DISK BOOT FAILURE error. Although when i plug in the CD, restart, and then dont hit a key to start windows setup, it works flawlessly and boots to the HDD.So my problem is im getting tired of having to have the system CD in just to boot (Takes up a CD slot). If theres any info about my computer you need just ask away.

EDIT - Will Check in the morning on any posts and or suggestions.

5 replies

by rob miners

Insert your XP CD and when you see ?Press any key to boot from CD? press a key. Now wait for the XP installer to finish loading up and you will be presented with the option to press R to Repair.

Press R.
The next screen will ask you which Windows? installation you would like to log on to. Normally the following will be listed:

1: C:\WINDOWS

Press 1, then Enter to continue.

You may now be asked for the Administrator password. If you know this type it and press Enter. If you don't know the Administrators password it may be blank. Just press Enter or type your username and password.

At the command prompt type:

fixmbr and press Enter

fixboot and press Enter

Wait until you are returned to the Recovery Console.

Once you are back to the Recovery Console remove the XP CD and restart your PC.

Let us know how you get on.

by oh smeg

If you do not know the makers name of the HDD you can use Seatools available here

http://tinyurl.com/yvq99t

If the HDD fails the test remove it and test again on another M'Board in a working computer. If it still fails the HDD is going faulty and needs replacing Now before you loose any Data. If it passes the second Test the M'Board is faulty and needs replacing before it damages the partition Information on the HDD and you lose your Data.

Also make sure that you don't have any Disc's in the Floppy Drive and if you have more than 1 HDD that the nonBoot Drives are disconnected. If it works now you need to either keep the Floppy Drive empty which it should be or reset the Boot Order on the HDD's by doing a Repair Install of the OS.

Col

by wownerd101

All tests were passed by both hard drives except the smart test, both of them failed SMART. Drives are a 320 GB Hitachi and a 500 GB Seagate. Trying a different mobo atm. Will post back to post results.

EDIT - Tried on a different mobo and it returned a no boot device found error on a dell machine. Plugged it back into my comp, switched the SATA cables around on accident and now it works. SMART test still fails but i dont know. It works somehow now.

This discussion is closed to new replies.