4 replies
by stevec77 Accepted solution
by older mycroft Accepted solution
That way, you could channel the solar powered charge, thus driving 120V AC units through whichever battery-powered system you have (either 12Volt or 24Volt).
A [u]residual current device[/u] wouldn't be a bad idea either.
by thechas Accepted solution
If the AC adapters all provide 12 VDC, you are correct that you would save power and improve efficiency if you connected your devices directly to your 12 volt DC battery bank.
However, I would not directly connect any DC powered device directly to your battery bank. At a minimum, you want to add a fuse rated for somewhere between nominal and maximum current draw for the device.
I myself would include a reverse polarity protection diode and perhaps a voltage surge protector. A switch in the power line would not be a bad idea.
You can build all of this into either an electrical box, or a small "Bud" box.
For your DC devices that use lower voltages, you can still bypass the AC adapters with voltage regulators. Just make sure to properly size them and allow for proper cooling.
For some detailed information on voltage regulator components, check out the National Semiconductor, Texas Instruments and EDN web sites.
For parts for the home hobbyist, check out All Electronics, BG Micro, and Hostfelt Electronics.
It can also be more efficient for devices that require higher DC voltages to use a DC to DC converter rather than an AC power inverter.
Vicor Power is but one company that makes a broad line of DC to DC converters.
Chas
by stevec77 Accepted solution
Thank you, Chas. I'll print your reply and suggestions off and follow it. Much appreciated.
Steve
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending