Discussion Locked

Can not add USB adapter to PC

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Summary of PC: Win98 (first edition) with 64megs of ram, 1.5Gig harddrive. The MB is a Tyan S1470.

I'm having major trouble with installing a USB adapter. The PC at first would not recognize the adapter, with a little reading on Tyans website itseemed that the BIOS needed to be updated to a newer version to recognize USB. So, I flashed the BIOS - this worked fine, no problems. Along with this, I also Flashed the CMOS - followed the directions from Tyan to a "T". Now I have 2 problems 1.)the computer sees the USB adapter and loads it in device manager but when using a USB device (i.e. HP Scanner) it does not see or recognize it. 2.) in device manager the network card (i.e. netgear F310) is installed but has a "!" and in properties its not being assigned a IRQ...any ideas?

4 replies

by rzan

Sounds like you have a hardware compatibility issue or are lacking the proper version of the driver for your PC. Check to see if your MB has a USB connector and a slot cover with 2 USB ports that attach to the MB connector. If you have an ATX board, it should have 2 USB ports already on the board. If you are installing an external USB card and you have a USB connector on the MB, make sure that your onboard USB is shutoff in the system BIOS. From what you describe in device manager, you are having some sort of IRQ conflict between your USB and some other device. Try disabling onboard USB if you have it, if not, see if your USB is conflicting with another device.

by missionx1

After flashing the bios, and Tyan saying that this would make the mb support usb, I found that the usb adapter still had problems with the system. The MB is AT form factor and has an attachment for a USB adapter that may/may not have come with the MB upon purchase - can not locate. The adapter being used is a D-link model DSB-500 that the MB didn't see intil the bios was flashed. The problems that I have now is that the adapter is seen but when I plug a USB device into it (i.e. HP desktop 932c printer) it does not see it. The second thing is the NIC card (netgear FE310) is not being assigned an IRQ. I have taken out all of the adapters except the video card and to no prevale its still recording a code10 error with or without the USB adapter installed. I've done all the troubleshooting that I can think of at this point and still don't have an answer.I would just like to install the nic card, get it to work and forget that this ever happened.
Thanks for the advice and any ideas.

by missionx1

After really working with all options and still wasn't able to get IRQ's assigned, I decided to install another motherboard that I aquired through a friend - free of course. Given that it was a new-er MB, I had to format the hard drive but other then that everything worked like a charm. IRQ's were assigned, the USB adapter worked 100% and was able to set up the USB printer and scanner without a hitch.
Now that this job is complete, I'm a stubborn irshman that will need to obtain an AT tower and try and find out an outcome to this delimer. Until then, thanks all for the info.

This discussion is closed to new replies.