Question Locked

Can not Ping a computer that was just re-imaged

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I can ping from the re-imaged computer to any other computer however when i ping the re-imaged computer it does not respond.
I can access the internet, I can go to the file servers with this computer, but for some reason, i can not ping this computer from other computers.

Problem Computer is on a LAN, running XP, with SP 3, computer was on the network before I re-imaged it. Windows Firewall is disable since we have a firewall set up with Cisco. File and Printer Sharing for Microsoft is checked off.

Before I re-image this computer does anyone have any idea what else i can do so that I can ping it. I was trying to install Sophos on to the computer but Sophos was telling me that the computer was not connect to the network, that is when i discovered that I can ping from that computer but not ping to that computer.

Thanks so much!

11 replies

by normh3

After you completed the reimage, did you manually add the PC to the Domain, or was the image that you used created after the PC was added?

by luv2bike2

I re-imaged the computer, installed all drivers (chipset, NIC, video, audio etc, it is a dell computer), connected to the internet, installed MS UPdates, added computer to the domain, tried to install Sophos Anti-virus. I can see all the computers and servers from the re-imaged computer. Ping from that computer to other computers --- good. Ping from other computers to that computer ---- no good. Tried to go to the C$ from my computer to the re-imaged computer and did not get a response.

Thanks,

by tonythetiger

when the re-imaged computer called the DHCP server, it was given a different IP address than the last one it had, but the router doesn't know about the change yet, so when you try to ping the re-imaged computer by its nodename, it's trying to ping the old IP address.

Go to the newly imaged computer, open a command prompt, and type IPCONFIG and press enter. Make a note of the IP address. Go to another computer and try to ping the noted address. This will probably work.

How to fix? Not sure, You can try IPCONFIG /FLUSHDNS from another machine and try the ping again, or you might try resetting the router. We get it once in a while under the same circumstances and it always seems to correct itself after a day or so.

by normh3

Now that I think about it, had a very similar issue a few months back. I wonder if flushing the DNS server cache would be a better way to go.

by tonythetiger

but in my case it's over 50 miles away and I have no control over it :)

by luv2bike2

I tried to ping once again to the problem computer and it worked. I was able to installed sophos without any issue.

Thank you all for your suggestions. i should have thought about flushing dns before but with all that i have going on here, my mind just went blank.
Thanks again! :)

by luv2bike2

I do it from scratch, format the hard drive, and install the OS from the original OS cd. however your point is a good one and I will remember (or at least try to) :) the SID when I do clone.

Thanks,

by luv2bike2

for your suggestions and/or comments! It was greatly appreciated!

This discussion is closed to new replies.