Question Locked

Can someone offer some direction on a RAM issue?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello -

Thank you for taking the time to help me. I have an older Sony Vaio (almost 4 years), and I have problems with my RAM not operating at full capacity, or anywhere near it. Until today, when I tried to install Dreamweaver, it hasn't mattered. The problem I have is that the system only reads around 50% of whatever memory I have installed, and I don't believe it's a port issue. I'm suspecting it's a configuration setting in my BIOS, but I really am not technically confident enough to start making changes to my BIOS, or to even know if this assumption makes sense.

My computer received a facelift 4 months ago when I upgraded (replaced) the hard drive, upgraded to XP,SP2, and doubled the RAM. Other than the RAM issue, the computer runs like a champ - no complaints at all. I'm not sure if the memory problem existed before this upgrade, but it does not appear to be a problem with the slots/ports - they both work. I have (2) 512MB sticks in there, and the system is only reading 448 total. When I take one of the sticks out, the system only reads 192. When I put the other stick into the other port, it still reads 192. I took out both new memory sticks and did the same tests with the old memory sticks, and I have the same results - around 50% of whatever amount is installed in either or both ports.

Has anyone seen this before? Any ideas? Let's assume I am using the correct memory sticks. The only way I am wrong is if the guy at Fry's was wrong. And I had my old memory sticks with me for him to use as reference. My computer is healthy and virus free.

5 replies

by w2ktechman

share memory with the system. But this should not be as much memory as described.

If you get into te BIOS, can you factory reset the BIOS (set defaults)?

by rentthese

Thank you for your response.
I'm not sure if I did what I was supposed to, but I did enter the blue screen setup section at system startup (F2), and found the option to reset to the default settings (F9) and then (F10) to save and exit, so I did that. I still have the same reading with my memory.

by thechas

W2K Techman is correct in that some of your RAM is used for the video. Most laptops and many major brand desktop systems use integrated or on-board video that uses shared system RAM for the video RAM.

Still, the video system will not normally use 1/2 of installed RAM. On a 4 year old laptop, I would be surprised if you can allocate more than 128 MB of RAM to the video.

I suspect that all of your RAM modules have memory chips that are a higher density than your laptop was designed for.

As I see it, you have 2 options:

1. Work with a local shop and have them try different RAM modules until they find ones that work with your laptop.

2. Use the RAM identifier tools at any of the major RAM suppliers web sites to identify the specific RAM modules that are designed for your system.

It also would not hurt to check if Sony has a BIOS update for your laptop that takes care of RAM issues.

If they do have a BIOS update, make sure that you follow ALL instructions for Flashing your BIOS.

Chas

by rentthese

I appreciate you working through some scenarios with me.

This discussion is closed to new replies.