1) The coaxial cable connects to the cable modem.
2) Run an Ethernet cable from the modem to your NAT (Network Address Translation) router.
3) Run an Ethernet cable from the output router port to your desktop computer. You might wish to skip the 1st output port, because it may be assigned a special function (check your router manual carefully for this).
4) Check the signal strength by hovering the mouse over the wireless network icon in the system tray.
Wi-Fi is short range 2.4GHz radio, essentially worthless beyond 150 feet from the access point. Here are some tips that may help reduce dropped connections:
5) A vertical booster antenna for the router can enhance horizontal coverage by ~50%
6) If the router is located one floor up or down from the laptop, consider relocating the router to the same floor
7) If the wireless adapters are 802.11g, program the router to broadcast only in [b]G[/b] mode
8) Enable SSID broadcast in your router setup
9) Configure the router to automatically obtain IP address from DHCP.
10) Temporarily disable encryption
11) check for 2.4GHz radiofrequency interference near the laptops (cordless telephone base stations)
12) check for RF interference (fans, motors, hard drives, etc.)
13) check for shielding (metal cabinets, etc)
14) If still no connection, try disabling the proprietary driver and enabling the default Windows wireless chip driver.
15) Look for a strong signal (>50% signal strength) from a channel close to the router's assigned channel. There should be 5 channels between such signals to avoid interference due to bandwidth issues. For example, if you see a strong signal broadcast on channel 6, program the router to broadcast on channel 1 or channel 11.
16) Check your laptop power management. Is there a timeout for the wireless adapter? If so, configure your power management so that the wireless LAN is always enabled and powered.
17) If you have a proprietary wireless chip driver installed, disable the Windows Wireless Zero Configuration (WZC) service: Control Panel > Administrative Tools > Services > Wireless Zero Configuration [right click > Properties > Disabled].
18) You may have to do some acrobatics to get everything stable once properly configured. This is the sequence that has worked for me:
18a) Disconnect the Ethernet cable from the cable modem
18b) Boot the modem
18c) Boot the router
18d) Reconnect the router-modem Ethernet cable
19) When nothing else works, check the Microsoft Knowledge Base:
http://tinyurl.com/msqye
20) When Microsoft can't fix it, consider Network Magic:
http://tinyurl.com/66x5cn
21) This is tip that worked for me: Don't use the built-in wireless adapter. Purchase a Linksys USB wireless adapter:
http://tinyurl.com/3vs8r7
Install the Linksys driver from the supplied CD. The WZC service should remain disabled. Whenever you wish to connect wirelessly, just plug the adapter into the USB port - nothing could be simpler (don't power on the built-in wireless adapter).
That about exhausts my suggestions. You may legitimately need encryption, but be aware that there is a penalty to pay for the complexities of this technology. If there are no likely snoopers within range of your access point, your wireless connection will be more predictably successful by disabling encryption.
Rick/Portland, OR