Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just installed a new server that runs Windows Server 2003 R2. I have connectivity to the cable modem but cannot connect to the internet. I have a Braodcom Gigabyte ethernet card in the server. I am new at this and not sure what all to install from the Server Management interface.I et the ip addresses by right clicking on the connection. When I click on the connection it even says it is connected. I hope someone can help.
3 replies
by ron.cluck Accepted solution
Clarifications
by doubleshocker Accepted solution
Go to Start... Run.... CMD [ENTER]
Type: ping www.yahoo.com [ENTER]
If the DNS is configured properly, you will see something along the lines of:
-----
N:\>ping www.yahoo.com
Pinging www.yahoo-ht3.akadns.net [209.131.36.158] wi
Reply from 209.131.36.158: bytes=32 time=25ms TTL=51......
-----
The key is that the DNS converted www.yahoo.com to (209.131.36.158) in this case.
If your DNS is configured correctly, let us know....
by jlouis45 Accepted solution
Have you checked the internet settings on the browser. Does it have an ip address and a port for accessing the internet. It looks like a browser issue if it is connected to the internet but you are not able to view the pages. Also let me know if you have a firewall. You would have to configure your firewall to access the intenet pages. Try to add the proxy or select automatically detect the settings and let me know the outcome.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies