Question Locked

Can't add XPs to new w2k03 Domain

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Greetings,

Configured a new test Domain server. DNS installed and nslookup is fine. None of the Workgroup XPs can join the domain:

A domain controller for the domain xyz.com could not be contacted...

1-All settings for preferred dns point to this server.
2-nslookup on xp fails for domain box lookup.
3-dns records on DC correct.
4-dynamic lookup: nonsecure and secure
5-/flushdns and /registerdns on DC and xp
6-using dsl router BUT tried adding using switch only
7-have sp2 for w2k03 server installed
8-ran dnsdiag on server: all pass
9-ran dcdiag on server: all pass except DHCP but static IP on all boxes

Please HELP!

5 replies

by danke

can you ping the server?
are you in between a firewall?
what did you do on the switch (VLANs, tagging, etc)?
is your switch configured correctly?
running through any ACL's?
does your xp box have the correct gateway?
does your xp box have the correct dns ip?

mainly can you ping your DC from the XP box (make sure the DC can respond to ICMP traffic)?
Post the DC and XP boxes IP configuration for us.

by johishi1

greetings ping pong,

i can ping ad/dns server using IP but not using server name. I tried adding the xp to ad/dns box with all fw disabled on both boxes and hooked up to only a switch. The switch is dumb so no configs necessary. When I tried this setup, I config'd gw to point to ad/dns box AND left blank since no gw was available. DNS IP is pointing to static IP on ad/dns box.

I notice this issue has happened in the past without answers on several forums. I have sp2 on the server box and tried this on another box running same OS/setup.

Any suggestions?

by danke

If it's dumb then it is a hub? Is it a hub or a switch?
Please post the IP NUMBERS for each box (IP, Gateway, DNS) so I can see exactly what you have set up.

So I'm assuming both IP's are statically addressed.
Did you tell your DNS server to listen for DNS requests on that IP?

Make sure your XP box is not trying to act as an authoritative DNS server, as well.
Make sure your DNS client service is running on the XP box.
Check your event logs on the DC and see if it's catching any weird errors.

by michael o'brien

Is your dns suffix on the network card set to your domains fully qualified name e.g yourdomain.com

Have you Wins turned on on your AD Domain controller containing DNS records ?

This discussion is closed to new replies.