Question Locked

Can't connect to win2k3 pptp vpn over T1

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a vpn sitting on a Win2k3 R2 server behind a Cisco 1841 router to a T1. I'm using a pptp setup. I can connect fine until I put filters in place. Then, after 5 minutes, I can no longer connect to the vpn from the outside. If I reboot the server or disable/enable the wan adapter, I can one again connect for 5 minutes. The filters are on incoming packets only:
For all filters
Src Addr: Any
Src Mask: Any
Dst Addr: WAN adapter IP
Dst MasK: 255.255.255.255

For TCP:
Src: Any
Dst: 1723
For GRE (Prot 47):
Src: Any
Dst: Any
For TCPest:
Src: 1723
Dst: Any

This setup worked fine and is still working on a DSL line. It seems like I must be missing a protocol or something associated with the T1.
Any help would be greatly appreciated.

3 replies

by tjordan

Been there. All filters match that format. The mystery is why this configuration works on a DSL line and not on a T1. The T1 provides internet access to my users and works just fine, which would indicate that the problem is not hardware related. This conclusion also supported by ability to access vpn when filters not in place. I still have the DSL-based vpn running and it works fine using the filters as I listed.

This discussion is closed to new replies.