1 reply
by joseph moore
I found a page on Cisco's web site that might be useful:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/c29xl/78492302.htm
(please remove any spaces)
Near the bottom is the section, "Cisco IOS 11.2(8)SA Caveats/Release 11.2(8)SA1 Modifications" and it states:
The following message is printed on the console after the user enters the enable command:
% No authentication server running
This happens if the user has previously entered the enable use-tacacs configuration mode command. [CSCdj75618]
There are a lot of posts in the Usenet about this too. The TACACS authentication method was enabled on the 2600, but no TACACS server was defined. So, the router is trying to find a non-existing server for authentication, and failing. YOu get the error as a result.
You need to go through the password recovery technique. See the Password
Recovery document on CIO under Technical Tips->Hot Tips at http://cio/warp/customer/701/22.html. It can also be obtained from our Fax On-Demand service
at 800-552-2447 as document #133
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending