Question Locked

CAT5 Troubleshooting

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a run of cat5 (50 feet). When I try to connect to the network I get limited or no connectivity.

When I reduce the distance to about 20 feet everything works fine.

I have tried several different peaces of cable and have the same problem.

I know cat5 is good for about 100 meters and I have ran long distances in the past with no problem.

I even tried cable off of two different spools.

I'm Stumped!

12 replies

by toivo talikka

Are there any sources for electrical interference and noise in the neighbourhood like air conditioning units or power cables in parallel with the CAT5 cable?

by jay.jennings

I don't think interference is the problem because after having the problem I moved the cable to our shop where I could troubleshoot with a different switch.

by mjd420nova

I had a similar problem, and it turned out to be a large transformer on the opposite side of the wall that was inducing interference. I had some old coax laying around so I striped of the rubber jacket and pulled the center conductor out and slipped it over the whole length and grounded on both ends. Problem solved.

by jay.jennings

I believe I have ruled out interference after taking the cable back to the shop for further troubleshooting

by awalworth

I've had something similar happen to me. I had a cable run that tested fine with a network tester. The older PC at the end of the run got a link, but nothing more. When I placed a dumb hub in between the PC and horizontal run, it worked. It turned out to be an aged network card. Once the card was replaced, the dumb hub (acting as a repeater) could be removed.

by mr.wiz

Is the 50' cable measured from the wall jack or from the switch. If measured from the wall jack, you could be exceeding the 100m distance if your switch is too far away. Also, check your ends and make sure you don't have a gap between the jacket of the cable and the RJ45 connector, that could cause interference.

by jay.jennings

I have actually taken the cable and plugged it directly into our cable modem and got the same results.

What are the chances of have two spools of bad cable?

by jay.jennings

Thanks but I have taken these cables to several different hubs or switches in our office and pluged the other end into several different laptops and I get the same results.

by luiss

JAY,

WHAT KIND OF CAT5E CABLE IS IT? STRANDED? SOLID?

HOW LONG IS THE RUN?

PLEASE PROVIDE ME WITH THOSE DETAILS AND I'LL HELP YOU FINDING THE ANSWER.

BEST REGARDS,

LUIS S

by luiss

JAY,

WHAT KIND OF CAT5E CABLE IS IT? STRANDED? SOLID?

HOW LONG IS THE RUN?
PLEASE PROVIDE ME WITH THOSE DETAILS AND I'LL HELP YOU FINDING THE ANSWER.BEST REGARDS,

by sgt_shultz

if this is a patch cable, my knee jerk is either:
you have the pinout miswired or an open at the connector. I look at the ends to see all the shiny wire down clear to the tip - or-
it's not the cable at all, you are being fooled by another problem.
why you making patch cables, I can't help but ask. as a beginner in particular i would recommend buying quality cables, premade, pretested. and spares. they are consummables.
if this is wall wiring maybe you could rent a TDR from your wiring supplier. Time Domain Reflectometer. a $2-6K tool for 'shooting the wire'

This discussion is closed to new replies.