Discussion Locked

Causes of defrag problems in Win 9x

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been experiencing a problem with my system that I havent been able to solve. Every time I attempt to defrag my system, it freezes to the point where I have to use my reset button to restart.

My system information:
amd 1.3 ghz thunderbird
k7vta soyo motherboard
320 mb pc 133 sdram
40 gb hard drive (partitioned as 1 partition)
running windows 98 second edition

13 replies

by gina

Some things to try, if you haven't already:
- Run a Thorough ScanDisk to check for and correct any errors found.
- Ensure all background applications are closed. Disable AntiVirus and screensavers. (You can use Task Manger to stop everything except Explorer and Systray.)
- Start Windows in Safe Mode and run Defrag.
- See Microsoft Knowledge Base article Q218160 for more detailed instructions on some of these suggestions.
http://support.microsoft.com/default.aspx?scid=kb;en-us;Q218160

Good luck!

by opatzg9

I thought windows 98 couldn't handle more than 32 gig for a drive partition? I had to keep mine under that when I installed but I installed 98 and then the 98 se update. It might just be that defrag won't work on drives larger than 32 gig. Flip side my motherbaord wouldn't auto id my 80 gig hd so I beeded the ontrac sofware to be able to use it. I cannot defrag my boot c: drive but I can defrag the other partitions. Ar you using ontrac or WD's drive support to handle the drive?
If soo youprobably need to go to them for the fix to make defrag work.

by captain krunch

Just an add-in, Gina is dead on for the most part. Do you have Norton Anti-virus/Task Scheduler or Utilities installed? Most AV programs will cause problems with Scandisk and Defrag. You need to disable them before running.
I have had problems with Symantec products (Norton) and Win98SE. Answer two brings up a point also. If you have Norton Utilities available try using Disk Doctor to scan and defrag the drive. Notron can be a cure or a curse, depends upon the system. I use it at work but have AVG on home sytems.

by thechas

In addition to the other tips, make sure that you have the large IDE hard drive cache update installed.
A few of the W98 updates can only be installed by using Windows update from www.microsoft.com\windows

Chas

by csmith

I have set up this configuration with Win98SE, and it works.
The cause of the defrag problem, besides some of the mentioned, can also be hardware.
This is usually a loose IDE cable or insufficient airflow over the HD.
Remember defag puts a lot ofstress on the drive, that means extra heat is generated.
Run a "thorough" scan disk.
If there are any errors, check for overheating.
(Put your finger on the running drive. Is it hot?)
Regards, Chris

This discussion is closed to new replies.