7 replies
by timwalsh
It won't read a specific CD, or it won't read any CDs? Is the CD a commercial (purchased) CD, or a CDR/CDRW?
If it is just one specific CD that can't be read, I would suspect that it is a CDR or CDRW that was created on another computer. If a CDR or CDRW is burned but the CD is not finalized, it will ONLY be able to be read by the CD drive that originally burned it.
Hope this helps.
by dpotter
by thechas
If this is true for ANY CD, you need to force a re-install of the IDE buss-master driver for the chip-set on the motherboard.
Start by deleting ALL 3 IDE controllers in device manager.
Restart Windows, and the new hardware wizard should take care of things.
Otherwise, you need to identify the system or motherboard, and download the latest IDE driver for it.
If this is a name brand system, you should be able to download the drivers from the mfgs web site.
Or, you can use the ID tools at either www.wimsbios.com
or www.motherboards.org
to identify who made your motherboard.
Download the W2K driver from them, and install per the instructions.
Chas
by dpotter
by skloo77
verify the issue by reading from dos.
boot up the system to dos. not command prompt.
then navigate to the cd-rom and do a 'dir' to see if the contents of the disc can be displayed.
if yes, reinstall your ide.
if no, pray to god, there could be some fault on your cd-rom.
by dpotter
by dpotter
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending