7 replies
by ann777
what you need to do is plan out a conversion of ip addresses. Map each of your 10.10.10.1 - 100 addresses to something in the 192.168.2.x range.
Print out your configuration of the routers and map those ip addresses as well. Neither the 10 or the 192 addresses are routeable. In your router configuration you will need to keep the external ip addresses and replace the 10's with 192's. It shouldn't be too difficult once everything is laid out.
You may need help from the manufacturersof your routers to configure those. If you have Cisco routers and have their support, call them for assistance. If you don't have their support, pull out the manuals -- I find them to be easy to figure out... especially when your router is alreadyconfigured. All you need to do is update ip addresses.
by stonebridge
by hayes1015
Try cisco configmaker. You may not be using cisco routers but you can still use the software to layout your network with the new IP numbers before you assign them.
http://www.cisco.com/warp/public/cc/pd/nemnsw/cm/index.shtml
by stonebridge
You can ease things a bit by assigning the servers with two ip addresses, one in the 10 and one in the 192 segment,enable routing, then create your new dhcp ranges and disable the old ones, so the clients get the new IP settings, and stil can connect to the "other sites". Make your DNS reflect the new settings and lastly make sure the routers know both routes. When all clients have gone to the new address range, you can delete the old 10 ip addresses from the servers and disable routing, and reconfigure the routers not to route the 10 range
Succes with it
by stonebridge
by stonebridge
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending