Question Locked

Christmas gift gone wrong

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently purchased a new mobo (Abit Fatal1ty FP-IN9 SLI Socket 775) along with a new stick of 1G DDR2 800 RAM, a GeForce 8600 GT and a brand new 550w power supply. Every time I try to boot the system, however, I can never actually reach the BIOS screen. My keyboard / mouse (both usb) do not light up and the monitor light stays orange. The weird thing is that the motherboard lights are on, video card fan is spinning and the cpu fan is on. What could be wrong? I've been banging my head against the wall (along with everyone I've asked for help) to try and fix this thing.

Any thoughts?

14 replies

by thumbsup2

More than likely, you'll need a PS2 KB and mouse to get started so you can access the BIOS and turn on the USB support.

by gjsmguss

ah that probably would help. I just came back from swapping out the RAM, Power Supply, video card, keyboard, mouse and monitor with my friends. Still no luck. The only thing left to change would be my case but, seriously, what are the chances of that being the problem?

by willcomp

Since there is no display, changing keyboard and mouse won't help at this point. PS/2 ones may be needed later but most mobos will handle USB with default settings.

Any beeps on boot?

Disconnect all external devices except keyboard, remove PCI cards (not video card obviously) and disconnect all drives -- both signal and power cables.

Try swapping memory or using old memory if it is compatible. Swap power supplies.

What we're dealing with is a boot failure. It's best to strip down to bare essentials for troubleshooting.

by thumbsup2

... the part about no video on boot. Sorry! Someday, maybe I'll quit reading over the posts so quickly.... LOL ;)

by tintoman

You said your mobo was socket 775 but you didn't say what your processor is or whether that was new or not.
The symptoms you describe suggest that the processor is malfunctioning to me or that it might be not properly seated, and lets not forget that despite the fact that the mobo is new it could be faulty.

by gjsmguss

My processor is a Pentium D 2.8ghz (I think) and I bought it in 2006. This mobo is the 2nd new mobo I've bought within the last 2 weeks with the exact same problem. The first was an Intel MSI P6N SLI-FI LGA 775 NVIDIA nForce 650i SLI ATX. To me, the chances that 2 different mobos could have the exact same problem are really slim so it must be the case. I'll try to set up the mobo on the table.

by oh smeg

just a thought. Can you test the CPU with a [b]Known Good M'Board?[/b]

by tintoman

Now that I realise you had changed the mobo twice I stick with my original theory that the CPU is malfunctioning, perhaps you belted it with static when you removed and installed it?

by gjsmguss

oh I hope not! I should be able to test the CPU sometime today.

by oh smeg

The fit the CPU and make sure that it's the proper way round, The Heat Sink/Fan, 1 Stick of RAM and the Video Card if you don't have On Board Video. I'm to tired to look up the M'Board at the moment.

Try starting again if you still don't get any joy pull the M'Board out of the case and place it on some clean unused paper on a table and try again. It's possible that there is something on the Backboard shorting out the M'Board.

Also fit the RAM into the Red Slot closest to the CPU.

OH what CPU are you using here?

Col

by cg it

Todays the big whoppers of Video Cards GPUs often require their own power source.

If your not getting a signal from the graphics card to the monitor, and you know the monitor is a known good one, then try reseating the the graphics card. If you have a motherboard that has 2 PCIe 16 slots try the other slot.

by gjsmguss

Tried that too. Swapping the card to the other slot (even with a completely different graphics card) doesnt fix the problem. The graphics card doesnt have a direct power source plug (kind of unusual but it works fine on my friends computer). The thing is, the fan on the card is spinning so it must be getting power.

This discussion is closed to new replies.