Question Locked

Cisco 2600 lab

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 3 Cisco 2600 Routers. All have a serial card WIC, CSU/DSU T1. How can I connect the routers VIA serial link with a cable? Will a crossover work, if yes how do the serial links need to be configured on either end?

Thanks...

5 replies

by kjell_andorsen

Get two serial cables, one designed for DTE and one for DCE, connect the ends of the cables together.

by rheadland

The interface on my serial cards are RJ45, is there any way to connect them directly using CAT5?

by mandeep4ulady

3(2600 Series Routers)....need 2 serial cables

FIRST HARDWARE CONNECTION
NOTE --- From Router 1, use SERIAL 0 to connect SERIAL 0 of the Router 2..........and, From Router 2, use SERIAL 1 to connect SERIAL 0 of the Router 3.

COMPLETE CONFIGURATION
***ROUTER1***ETHERNET PORT(E0)
interface e0
IP address 10.0.0.1 255.0.0.0
no shut
no keepalive
exit

***ROUTER1***SERIAL PORT(S0)
interface s0
IP address 20.0.0.1 255.0.0.0
no shut
clockrate 64000
exit

router rip
network 10.0.0.0
network 20.0.0.0

.............................................

***ROUTER2***ETHERNET PORT(E0)
interface e0
IP address 30.0.0.1 255.0.0.0
no shut
no keepalive
exit

***ROUTER1***SERIAL PORT(S0)
interface s0
IP address 20.0.0.2 255.0.0.0
no shut
clockrate 64000
exit

***ROUTER1***SERIAL PORT(S1)
interface s1
IP address 40.0.0.1 255.0.0.0
no shut
clockrate 64000
exit

router rip
network 20.0.0.0
network 30.0.0.0
network 40.0.0.0

.............................................

***ROUTER1***ETHERNET PORT(E0)
interface e0
IP address 50.0.0.1 255.0.0.0
no shut
no keepalive
exit

***ROUTER1***SERIAL PORT(S0)
interface s0
IP address 40.0.0.2 255.0.0.0
no shut
clockrate 64000
exit

router rip
network 40.0.0.0
network 50.0.0.0

..........................................
Did it work ? let me know

by rnkerrigan1

But what if they are wic cards with RJ45 ports? Is it possible for serial interfaces to work in a lab environment with a cross over cat 5 cable?

This discussion is closed to new replies.