Question Locked

Cisco 2940 switch for telnet access - Cisco newbie

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

Trying to setup a Cisco 2940 switch for telnet access. I have an IP address assigned to VLAN 1 with a subnet mask and have set the line configuration for the max allowable telnet sessions. When I do the telnet command TELNET 192.168.1.253 no worky, cannot ping the device either.

Any suggestions would be great.

Thanks,

Tony

1 reply

This discussion is closed to new replies.