Question Locked

Cisco 2950 Switch

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all,

I have a problem with my Cisco 2950 swicth. sometimes this swicth is not pinging nither able to telnet , but the most suprise thing is that all the ports remain up and working.
I Can access this Switch from Console.

Please help on this ......

6 replies

by ccthompson

I am having the same problem. Have not found a solution as of yet, the only way I can get to the switch is connecting through the console port on the back.

Hope someone on here can help us out.

by cg it

did you configure this switch or did someone else?

by cg it

I would look at how it's configured and possibly reload or set defaults for the running config.

by tibor.kovac

you must setup vty password for telnet.

switch>en
switch# conf t
switch(config)# line vty 0 15
switch(config-line)# password somesecret
switch(config-line)# login
switch(config-line)# end
switch#copy run start

This discussion is closed to new replies.