Cisco controller 4402
Does anybody have an "how to" configure a Cisco controller 4402?
Any and i mean any help will be great.
Thanks in advance,
Joaquim
jafspt@gmail.com
Networks
Does anybody have an "how to" configure a Cisco controller 4402?
Any and i mean any help will be great.
Thanks in advance,
Joaquim
jafspt@gmail.com
by jafspt Accepted solution
by acedescuatan Accepted solution
Well, im not entirely sure of the steps but we did start with setting up the interfaces. Both for ap-managment and the management interface. The ip addresses were setup as well as the DHCP and gateway. The controller was then set to layer 2 mode to allow the LWAPs to communicate to each other and to the ap-management interface. As soon as you get the ip addresses of the APs in the WLC save configuration and reboot and set the controller to layer 3 mode. then you can start with creating WLANs.
This is pretty vague but i hope you get the idea. You can find more and maybe a detailed instuction from ciscos website.
This discussion is closed to new replies.
Sort by Trending