Question Locked

Cisco home lab frame relay questions

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all,

I just got my small lab to play around with. I have 3 routers,

Cisco 2503
Cisco 2621 and wic-1t
Cisco 2620xm and wic-1t

1. If i want to practice frame-relay, can i configure 2503 as a frame relay switch? ... since it has 2 serial ports and i have two routers

2. But i see most people use a NM-4as for frame relay. Is there any scenarios that i need 2 physical serial links for a router? i heard somewhere about multi link or multi point, care to explain?

3. and between wic-1t and WIC-1DSU-T1‎ in an home lab environment, any difference in terms of functionality? i think i can do frame relay with either one of them (using different cable types), but any other differences?

Sorry for those question, i'm a newbie in cisco stuff.
thanks so much.

6 replies

by cg it

better to get routing and switching down pat along with subnetting and addressing that you can do in your sleep before frame relay. Then there is OSPF, IGRP, EIGRP, RIP to learn all in my opinion, before frame relay.

by donmecca

I agree... Are you studying for your CCNA or CCNP? I would review your objections and go from there.

by superkingkong

hi,
thanks for your reply. I've actually gone through the CCNA course two years ago but i didn't go for the exam.

But i think i've forgotten most of it now.

The reason i'm asking these questions because recently i've got hold of few routers, and i would like to learn about this frame-relay.

I don't think the questions i've asked are covered in the CCNA course... it's kind of more technical

I have no intention of going through this CCNA again... anytime soon.

But i would like to play around with the routers.. as per my questions.

i would appreciate if anyone has the answers to my questions, please let me know, thanks.

I know, some of you might say, if i'm not going for my CCNA, then don't touch Cisco stuffs.

But, i've bought them, and have no intention of selling them off.

So, if anyone could help, please. thank you

by cg it

between the routers..... if the 2503 supports frame-relay virtual circuits on the serial interfaces.

For the how - well doing is learning....

by superkingkong

Thanks for your reply.

In frame relay, are there any situations where it'll need 2 serial interfaces for a particular router?

or, only one is needed at anytime?

thanks.

This discussion is closed to new replies.