Networks

Ask something
Question Locked

CiSCO IP Routing

0 helpful
6 replies

by pv.consulting

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi Guys, i have a cisco 2611 and a 2691. they both have quite a few tunnels and ip routes. recently i am experiencing an issue where i create a static route, wr t it, and the route is not there. i can create tunnels all day, but static routes are not sticking to the config. any ideas?

6 replies

by nimmo

Try using the Permenant command at the end of the route entry.

by pv.consulting

thanks guys, in actuality, the routes were not sticking because the interfaces were not up at the time i was making the route. something simple and stupid, but i figured it out due to your hints. thanks.

by nimmo

The perment command at the end of the route command entry is ment to keep the route entry even when the interface drops.

by vicki.fox

I had a similar problem with a FWSM. Turns out it was a bad version of code.

This discussion is closed to new replies.