Question Locked

Cisco ospf help needed

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have 2 routers,i want to configure a ospf in two of them,but not a regual one,but a one that will be able to transmit and recieve from the other router

i have been told that i need to make something that will include a loopback interface but i didnt understood so i wrote were this msg..

tnx to you all
:)

2 replies

by dthomason119

A loopback address is a address that only exists in the mind of the router. It's a virtual interface. If you are in configuration mode then you can type int loopback like the example below:

router(config)#int loopback ?
<0-2147483647> Loopback interface number

After you do that you can give it an IP address like any other interface.

This discussion is closed to new replies.