Question Locked

Cisco PIX 501

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a PIX 501 that was returned to my office & no one knows any of the passwords for it. I've tried the password recovery process & it's not working. I need to know how to restore factory defaults without the passwords. Can ANYONE help???

2 replies

by jmoody

To remove passwords on the PIX firewall, you will need a file from the Cisco Web site that corresponds to your version of the PIX OS. The file is called npxx.bin where xx is the version of OS running.

nppix.bin for pre-version 5.0, np50.bin for version 5.0, np51.bin for version 5.1, and np63.bin for version 6.3 of the OS.

To use the NP files, put them into a folder accessible by your TFTP server and perform the following steps:

1. Reboot the PIX
2. Enter the Monitor Mode (press Break or Esc to interrupt flash boot)
3. At the Monitor > prompt, type the following commands:
Interface 1 This sets the inside interface for TFTP
Addresses a.b.c.d Use the inside interface of your PIX from the map for a.b.c.d
Server m.n.o.p Use the address of your TFTP Server for m.n.o.p
File NP63.bin Use the file that is correct for your version of PIX OS
TFTP To start the download
4. Type y when presented with the question "Do you wish to erase the passwords? [yn]"

This discussion is closed to new replies.