Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I was trained how to open specific ports on my cisco router, however, due to recent changes and the hook up of IP Phones I Need to open a broad range of ports, but I dont see an option to open a range, only the option to open one at a time. How do I open a range of ports on a Cisco 2801 series router.
3 replies
by junkmail1025 Accepted solution
Clarifications
by cg it Accepted solution
here's a link for the firewall feature set that supports PAM for IOS 12.2
here's a link for basic router config on the 2800 using SDM
by gurowar Accepted solution
I'm sure on a 2801 it should be the same but on a 2811 I normally do the following:
config t
ip access-list extended test
permit tcp 1.2.3.4 0.0.0.255 5.6.7.8 0.0.0.255 range 7000 9000
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies