Discussion Locked

CMI SOUND CARD (CAN'T CONFIGURE)

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to configure a cmi8738 pci sound card 4 channel in a couple of different machines with no success.I have done everything by the book.
Went to the cmedia site and tried both sets of drivers.I load everything and when i reboot i get the error message "exception error in oe at 0028-c000b28a in vxd-vmm+0000a28a".I know this is something to with virtual memory.Any suggestions?

5 replies

by thechas

What version of Windows, and how much RAM is installed in the PCs?

This sounds a bit like the W98 / Me memory bug.
The older versions of Windows have a bug where if you have more than 511MB of RAM installed, they can actually loose track of the first 512MB, and run out of RAM!

Next, I would suspect a slot conflict.

Check the default IRQ assignment list for the motherboard.
Depending on what slots are used by other devices, you may have an actual hardware resource conflict.

If it is not installed, install the chip-set drivers for the motherboard.
Many new motherboards cannot properly configure PCI devices without first installing the PCI bridge driver.

Chas

by guruofdos

Any exception starting with 0028 refers to graphics or sound and drivers in memory.

I'd remove the card and see if the problem goes away. If it does...remove the drivers and check that mixer.exe isn't in the startup. Re-install the card using thesetup program that came with it...DO NOT let Windows install the card....just hit Cancel when the card is found, then install from CD. You will need to browse to your windows\inf\other folder and remove any *.inf files to do with CMedia or CMI

This discussion is closed to new replies.