Question Locked

CMOS checksum error problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Dear people hello,
here is the problem i have. This is my system :
------------------
System Information
------------------
Operating System: Windows XP Professional, Service Pack 2
System Manufacturer: AWARD_
System Model: AWRDACPI
BIOS: )Phoenix - Award WorkstationBIOS v6.00PG (SIS 648 FX-A)
Processor: Intel(R) Pentium(R) 4 CPU 2.80GHz (2 CPUs)
Card name: NVIDIA GeForce 6600 GT
Memory: 1024MB RAM

The other day changing some settings in my BIOS i had black screen and no response when i tried to enter setup (del). I cleared the JP1 jumper, which resets my bios settings to defaults. After that everytime with my first boot, and only with my first boot, i have a checksum error message telling that a new cpu was detected and prompting me to press F1 to continue or DEL to enter setup. I 'm changing some settings but when i turn off and boot again i have the same message and the date and time of my cmos is reseted.
I tried the following with no result:
1. Changed the cmos battery with a new one
2. Load Fail-Safe Defaults option
3. Load Optimized Defaults Option
Another thing that i noticed is that there is an option in my bios settings which is called :
Over Clock Function (enter)
When i press enter i can see the following options :
CPU frequency (200)
Over CPU Vcore function [normal]
Over DDR Vcc function [normal]
CPU:DRAM Frequency Ratio [SPD]
I think the value on CPU frequency, wich is 200 in my case is a bit strange. What do you think ? Do you think tha changing this value in 100 fo example will resolve my problems ? Do you have any suggestions for my problem.

Thank you in advance

5 replies

by hal 9000

You need to save any changes before exiting and that this option isn't being utilised so that the alterations made to the BIOS are not saved when you exit the System and you get the error message on the next boot.

Naturally I'm supposing that you changed that jumper back to where it's supposed to be and that it's no longer currently set to the Clear BIOS Setting.

However if you are doing everything properly follow the MSI directions and unplug the system and leave it for about 20 minutes without any power and then plug back in and alter the Stock BIOS Settings and save on exit and that may cure your current problem. If it doesn't you'll need the M'Board Manual to make sure that you are setting everything correctly in BIOS.

Col

by pkarani1

Problem solved by just installing the battery the wright way (writing up).Thank you

by love_allah_1

installing the battery just
new battery or the same battery ??
and are there settings i did that???

by ajay_soni01

dear i think ur bios firmware hasbeen damaged or corrupted so u should update ur bios firmware . lets try may be it resolve ur issue.
if ur issue get resolved and plz intimate me.
thx byee

This discussion is closed to new replies.