Question Locked

cmos checksum-processor not known-cannot boot- new board and processor

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

jsherm3 new m860 pc chips mobo and new amd 3400 semperon proc. the problem is it starts to post but there is no bios. after it lists the drives it ends with the message ;
cmos checksum bad
cmos date/time not set
*****warning: unknown processor****
the processor installed in your system is not known by the bios. please contact your bios vendor for appropriate updates.
fatal error...system halted

then there are two quick beeps and it halts.any help will be appreciated.

5 replies

by captbilly1eye

Is this a custom-built system?
Has it ever worked?
Could it be related to a bad flash of the BIOS? In other words, did you recently try to update it?

A CMOS check sum error is usually caused by corrupted data in the CMOS memory. It could be caused by a shorted motherboard. If it is brand new, you probably should return the MoBo for a replacement under warranty if possible.

Other than that, I would:
1. Check the board's CMOS battery.
2. Reset the BIOS - consult the MoBo's manufacturer or its service manual for exact instructions (involves moving jumpers). You may also want to try flashing to an earlier BIOS version.
3. Reinstall the chipset drivers if possible.

According to PCChips that board is compatible with Sempron processors,so the next thing to do would be to test the processor using another board.

I hope this helps.

by gary56789

the BIOS specifics, I'd guess that one of the RAM chips either needs reseating or replacing (try one at a time in the number 1 slot).

by james_hernon

Yo mate the problem might be caused by old or incorrect data in the CMOS. Just open the case of the PC locate the CLR_CMOS.

CLR_CMOS: Clear CMOS Jumper
Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the Setup
Utility are incorrect and prevent your motherboard from operating.
To clear the CMOS memory, disconnect all the power cables from
the motherboard and then move the jumper cap into the CLEAR
setting for a few seconds.
CLR_CMOS

Function Jumper Setting
Normal Short Pins 1-2
Clear CMOS Short Pins 2-3 <-----

Please leave it shorted fopr about 2 - 3 seconds and also make sure you remove the little cr2032 battery before you move the platic thingy to short pin 2-3.

I hope this clears up the cmos bad checksum and that after you replace the batter and put the platic thingy on pin 1-2 you should be able to boot the machine and press F1 to enter setup and put the right BIOS settings in there.

Thanks
James Hernon

by james_hernon

Hiya mate,
This may also be one of the problems in that you may need to update or reflash the BIOS on the MOBO to recognise that combination of NEW CPU and MOBO... the only way to do this would be to obtain a CPU that the MOBO recognises and then flash the BIOS UPDATE and then install the NEW CPU which would then be recognised by the BIOS.

Bring the MOBO back to where you purchased it retail and tell them that the current BIOS doesnt recognise this NEW CPU and that the BIOS needs updating to recongise the CPU your trying to install.

But try resetting the CMOS first before you return the MOBO/CPU.

I hoooope that I have been of some help mate.

Thanks
Jimbo

This discussion is closed to new replies.