6 replies
by skot139 Accepted solution
by mjd420nova Accepted solution
by hal 9000 Accepted solution
First things first. As this is a new unit I would first test the Hardware to make sure that it's working properly. There are several ways of doing this but the fastest & Easiest is to grab a Live Linux and allow the computer to boot off the CD/DVD and see if it runs correctly. As Linux will be loaded into RAM it will not do any damage to the Windows install as it doesn't access the HDD for anything and you can run a full test on the Hardware involved.
If you use Knoppix you'll be able to access the HDD to see what's on it and make any changes that may be necessary.
You can buy or download a copy of a Live Linux from here
If the Hardware checks out as OK you'll need to run some Virus & Spy Ware Scans to try to clean up the system. As you have not mentioned any AV product that you have installed I would suggest AVG available from here
At the same time you can download Spy Bot S & D and Ad aware SE from these sites
Install these and then update them from their Internet Sites by choosing Check for Updates and when they are installed & Updated boot into [b]Safe Mode[/b] and run the scans.
[b][i]Remember[/i]Safe Mode doesn't mean that the OS is Safe it only means that it's safe to work on the OS and attempt to repair it so never log onto the Internet or a Network while running in Safe Mode.[/b] To get into Safe Mode press the F8 Key during the POST process and then scroll to the Start in Safe Mode option.
While not to likely I would try it with another mouse as well as it's possible that something is sticking in the mouse causing applications to open several times from a Desktop Shortcut.
If necessary you can try a Repair Install of Windows by following the directions here
http://support.microsoft.com/kb/315341
If you have encrypted your files you'll need to save the Encryption Keys or you'll loose all your data the directions are available here
But if you have been running without any AV Software I would suggest blowing away the entire installation and reloading the system after wiping the HDD to remove every trace of any infection with a utility like Boot & Nuke available from here
Col
by csmith Accepted solution
The only hardware problem this can be is a defective mouse.
You are getting the normal beep at the end of the POST, so the BIOS has checked for stuck keys on the keyboard, graphic card problems, bad RAM, etc. and there are none.
Easy test: unplug the mouse and boot the PC.
You will get the warning message that Windows can not find the mouse, but the PC will act normally.
Note: you should use only keyboard commands to shut the PC down, but not required.
Mouse failures this early are abnormal unless you are in a machine shop where there is a lot of metal dust in the air. So the mouse failure is unlikely.
The most likely problem is that the PC is infected by a rootkit.
The symptom that points to this is the second beep.
I have found no AntiSpy/AntiVirus that works reliably against this problem.
That means manual removal.
The usual solution is to run HijackThis, look at the output, and manually delete the offender.
If you do not understand the output of HijackThis, save the output to a log file, and show the log file to some one who does.
Regards, Chris
by skot139 Accepted solution
Thankyou for all of the feedback on this.after i changed the keyboard i was using the pc booted up as normal.
if you could chris would you check back on this and i will post the output of the logfile from hijack this if you could have a scan over it for me.
cheers, scot
by jamesatmaisonverre Accepted solution
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending