Question Locked

computer does not boot up

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I restarted my computer and it went through its startup and the floppy drive and cd rom lights came on and the dell logo came up on the monitor and then the logo went away as usual but that is where the reboot stops. No windows xp screen. Just a flashing cursor in the top left corner of the screen. Can anyone help? It is a dell xps t550.

16 replies

by oh smeg

The CMOS Battery may be flat and need replacing. These are a coin cell of the CR3032 type generally speaking and cost under $5.00 for the part and only requires you to reset the Date & Time and save the settings as you exit the BIOS to get working again.

You can also try unplugging the unit and press the On Switch for 30 Seconds to discharge the capacitors as this may clear an electrical Issue that has arisen.

If that doesn't cure the problem you need to post back with exactly what is happening here.

Col

by niktone

Does It automatically reboot? or it just hangs at the screen with the blinking? Could be that the operating system files are corrupted and you may need a reinstall of the O.S. Or like Oh Smeg Said the CR2032 Battery could be failing those are all possibilities

by jama yassin

you didn't explain much, but i thought the problem is Bios, go to your bios and select Boot, in the boot select HDD first, save and quite.

if the problem continue check HDD Data and power Cables,

sorry my poor english.

by tnmccoy

I can't get to the bios. I have tried hitting the f8 key as it is booting and nothing happens. Eventually the F keys only beep.

by tnmccoy

The computer does not automaticly reboot. It just hangs at the screen with the blinking cursor. How can I reinstall the OS from the blinking screen? I tried booting from the XP disk and it would boot from the disk.

by maxpowers410

You get a beep when it start up? Just one means its ok, if you get more then check out the beep code online for that motherboard...

by tnmccoy

I have just one beep as always. I have now changed hard drives and all works. But I would like to fix my larger faster and newer hard drive. See my other posts for the help I need.

by tnmccoy

I installed the original 10G hard drive that I replaced 2 years ago with the new 160G and the computer booted up. I am now assuming that the hard drive crashed on reboot. I had tried to reboot with the xp disk but I got the same result. I am going to try to slave the removed 160G Western Digital hard drive and see if it can be read. Could the OS have locked up and just need to be reinstalled? Thanks for the help.

by tnmccoy

Ok I am happy the hard drive has not crashed as I can slave it and read the files but I can't boot from this hard drive when it is set as the master. Has my operating system gotten corrupted? How can I repair the operating system if all is does is show a flashing cursor in the left hand corner with the rest of the screen black?

by yasirksa1

if you are able to access the hard drive as slave, first take the backup of all your files in another hard drive. And make it master again and then try to reinstall the OS by putting the bootable XP CD if it detects the hard drive. And then reinstall the OS.

by rob miners

on the drive while it is connected as a Slave.

Put it back into the System as CS or Master

Insert your XP CD and when you see ?Press any key to boot from CD? press a key. Now wait for the XP installer to finish loading up and you will be presented with the option to press R to Repair.

Press R.
The next screen will ask you which Windows? installation you would like to log on to. Normally the following will be listed:
1: C:\WINDOWS

Press 1, then Enter to continue.
You may now be asked for the Administrator password. If you know this type it and press Enter. If you don't know the Administrators password it may be blank. Just press Enter or type your username and password.

At the command prompt type:

fixmbr and press Enter

fixboot and press Enter

Wait until you are returned to the Recovery Console.

Type bootcfg /rebuild

Once you are back to the Recovery Console remove the XP CD and restart your PC.

by tnmccoy

I tried your suggestion and no luck. After following all steps when I reboot I have the same problem. I have backed up what I need on the drive when I slaved the drive and I am close to formatting the disk and reinstall Windows or use it as a storage drive. Any former Dell techs on here that can help?

by reisen55

I hit this one with another XPS 1550 last year, and if your BIOS has raid built into it (and with one hard drive that is stupid), then there is a possible problem with the Intel disk controller chip on the motherboard and Windows XP. Your hard drive is there, but the motherboard and XP disagree about how to get to it and nothing happens. I forget the exact screen error but you can upgrade the BIOS - easy - AND check changing your RAID settings. Another intel patch exists for Windows, but if you cannot get into Windows that is moot.

Several message boards had extreme user frustraiton on this one and even Dell techs were pissed about it.

by rob miners

Use this at your own risk as I haven't tested it as yet but it looks promising.

Fixmbr - Repair Master Boot Record

Site
http://www.ambience.sk/fdisk-master-boot-record-windows-linux-lilo-fixmbr.php

Download
http://www.ambience.sk/experiments/MbrFix.exe

Command to run if you only have one Hard drive in your System. If you have two hard drives check the instructions by clicking Fixmbr from explorer and it will create a html file for perusal.

Press Winkey + r and type in cmd and press Enter. Navigate to where you copied MbrFix and then type the following commands and press Enter after each command.

MbrFix /drive 1 savembr Backup_MBR_0.bin

MbrFix /drive 1 restorembr Backup_MBR_0.bin

MbrFix /drive 1 fixmbr /yes

The first command will backup the MBR to test if it is working, along with the second command. The third command will rewrite the MBR.

With the external drive attached press the WinKey + Pause/Break and click the System Restore tab. Stop monitoring the drive and the system volume information directory should be removed.

by reisen55

Open it up.
Pull the hard drives out
Pull the memory out
Pull every expansion card out.

Turn it on.
Let it beep like crazy.

Put in a video card, see if you can see BIOS through this alternative.

Then begin putting all of the above back in again and rebooting each time.

This discussion is closed to new replies.