Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Computer worked fine 3 days ago then turned it on and it stopped at the compaq logo. down at bottom left of screen gave choice of boot order or f10. per Hp tech have reseated memory, re-seated harddrive, drained battery and set bios to default. When i do a hard drive test in bios is says ide device not detected. Tech person said to send puter in for them to check. said will cost 298.00. Economy sad don't have that kind of money. Any other help? Running windows vista. Came with ie but upgrated to vista a year ago- working fine since untill 12 nights ago. If let it sit at logo icon it finally goes to blank screen with blinking curser in upper left but won't go any further. PLease, PLease help
3 replies
by whitelace78 Accepted solution
Clarifications
by rob miners Accepted solution
by sgt_shultz Accepted solution
doublecheck the power to the hard drive and the cable. make sure it is not on 180 degrees off (usually it's keyed so you can't install it wrong). if you can feel the drive spin up, you may have a bad ide controller but more likely a bad drive.
sounds like its time for a new hard drive. take the computer with you to buy it. put the old one in as a slave in case it can still be read from. you never know. if it can you can use the new drive installer utility from whomever made the new drive to copy your old one.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies