Question Locked

Computer just stops recognizing slave drive

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have never come across this issue before. I have a computer with a slave drive. The Master 40gb and the slave is 40gb. Everything was working fine until one day the computer stops recognizing the slave drive. Nothing has changed in any settings. The bios does not see the drive and of course neither does the OS. But I can feel that the hard drive is on when my hand is place on the drive. The computer is a Compaq Presarios 6000 that has had it's motherboard replaced last year. The OS is Windows XP but at this point, software seems irrelevant. Any ideas?

8 replies

by older mycroft

The 'Presario 6000' was launched with an 80GB hard drive, so I'm assuming that it's a partition problem rather than a cabling problem with 2 different bits of hardware.

Have you checked in Disk Management? The BIOS is unlikely to 'see' the second partition as it's only interested in hardware.

What was the last thing you were doing before the 'slave' disappeared?

You may have to consider that this 6-year-old drive is beginning to fail. Does this system have SMART reporting in the BIOS? If so, it would be a good idea to enable it, although it might already be too late.

by kenney.jasond

You are right that the hard drive is 80GB. This is a completely separate drive. Like I stated, I can hold it in my hand and turn on the computer and hear and feel the power in the drive. The bios is not picking up the drive. Nothing has changed in the computer. I can check to see if there is SMART bios.

by rob miners

that you have a second physical drive connected and it is not being detected in the BIOS. Try another IDE Cable and 4pin power connector. Check again and see if it is detected in the BIOS. The drive may be spinning up but if the controler card is gone then the drive has gone to silcon heaven.

by kenney.jasond

Instead of swapping IDE cables. I attached it to another computer and received the same problem. I think there is a problem with the actual drive itself because it was working just fine. The drive is spinning up I can feelt it but the bios does not detect, in either computer for that matter.

by szester112000

But i have ran into this problem before. It ended up being the actuator arm on the hard drive sticking. I bumped mine and it started working again.

by kenney.jasond

I tapped the hard drive with a small hammer and it sounded like the actuator arm was clicking. I tapped it again and the clicking stopped but the computer still did not see the hard drive. I am almost to the point where it is a lost cause. I will now need to find a company that can pull the data off.

This discussion is closed to new replies.