Nothing can be detected in Windows if the BIOS don't see it first.
Did you bend a pin in the plugs or plug a cable in backwards? Did you jumper something wrong (ie; master/slave)? Did you mistakenly plug all 3 devices into the same data cable and nothing goes to the motherboard controler? Did you plug in the power cords? If you have 3 IDE devices, you must have 2 data cables and two controlers to plug into on the motherboard. Each device must be jumpered according to which cable it's on. The cable with two devices will have a master and a slave. The cable with one device on it will be set as master. Or, sometimes they can all be set to cable select, depending on the cable you're using. But, that's a horse of a different color.
Try getting one device at a time to work. Make sure that device is jumpered as master and very carefully plug in the data cable to the device with the BLUE end connected to the motherboard. Don't force the plugs. Then, plug in the power cable to it. Boot up and see if the BIOS detects it. If it does, shut down and plug one more device in, jumpered as slave on the same data cable and a separate power cable. Do the BIOS see it?
Also, try another IDE cable remembering that one end is designated for being plugged into the motherboard. Usually, this end is blue.