Question Locked

Computer starts up and monitor turns on then off, as if receiving no signal

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Geek Squad recently replaced the PSU in my pc, is is now 650W. They also re-applied the thermal paste to the PCU.

It's been working for 2 weeks now. Last night I was using my pc...I heard a beep and then the computer shut itself off.

I felt the Liquid Cooler fan, it was too hot to hold on to, So i'm figuring it over-heated.

Now I turn it on and the actual tower works like it normally does, no ran lights or periodic beeps. Minus the normal beep on boot up.

However, the monitor will start up, normal blue screen, then it never goes to Windows. The computer just turns itself off.

Any thoughts/solves are appreciated.
Thanks.

4 replies

by Former member

Just take off your heatsink and fan, the very carefully wipe off the paste, make sure you take it all off (the paste that is). When all is off apply a very very small amount of thermal paste and just smear it lightly over the processor the re-attach the heatsink and fan. When done connect your computer and start it up.

Please post back if you have anymore problems or questions.

by rob miners

It may benefit you to install an extra cooling Fan to help dissipate the Heat. Here is a link to an article that can guide you.

THE HEATSINK GUIDE: Case Cooling

http://www.heatsink-guide.com/

Start by turninig off the power to the PC from the wall and remove the power lead from the PC. Remembering to ground yourself by getting into a position that will allow you to access the components without moving your feet and putting the back of your hand on the PSU after you have removed the PC's Cover. By not taking this precaution it is possible that you could inadvertantly cause damage to the PC from an electrostatic discharge. Disconnect the 20-24 pin power connector from the motherboard. Reinsert the 20-24 pin power connector to the motherboard. Remove the Video Card and clean the golden edge of the card with a soft rubber eraser, remembering not to touch the golden edge. Reinsert the card and add your new Fan making sure that it is oriented in the right direction and see what happens.

by oh smeg

What is this?

Is this fan actually running or has it stopped spinning?

Is the level of the Liquid in the reserver at the correct height?

It is possible that a Fan has quit and is jammed causing a Short Circuit which is overloading the Power Supply and causing the unit to shut down.

I'm also at a loss as to what this means here too

[i]Now I turn it on and the actual tower works like it normally does, no ran lights or periodic beeps. Minus the normal beep on boot up.[/i]

Which lights the Front Panel Lights for Power and HDD Activity as well as the light in the Optical Drive isn't showing? Is that what you mean here?

If it is the Power Supply either isn't providing power to these components or the M'Board is shot. If you have had a leak in the Liquid Cooling System as well the chances are that the M'Board has been fried as a Short Circuit has occurred on it while there has been power Applied.

You need to check every Fan including the one in the Power Supply for Function. If any are not running but spin freely the Power Supply & or M'Board need replacing.

Col

This discussion is closed to new replies.