Question Locked

Computer stays in black after leaving on overnight

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I discovered my Windows XP home computer will not wake up again when left overnight. It works fine and when I am finished I get up and walk away from it, the screen eventually goes to black and will not come back up the next day. I have to power it off and back on again and reboot it. I have used Registry Cleaner and defragmanted the hard drive with no success.

Any ideas???

9 replies

by bfilmfan

The video card isn't powering back up when recieving a wake up signal.

Check to see if you have the latest drivers and firmware installed.

by tjopplin

I first discovered the problem when my laptop would no longer connect via Remote Desktop. Would the video card take my home computer off line when it goes to black?

I appreciate the response.

by seanferd

Are the power management capabilities of the ethernet card set to allow the card to wake the system? Are any settings in BIOS setup set to allow this?

In power management, is the system set to standby or hibernate? If standby, what are the standby settings for monitor, disks, and system? Check the S settings in BIOS for this, if available, Try S1 instead of S3.

Updated video drivers definitely can help.

Run chkdsk to see if there are any corrupted system files.

DVI video is known to cause issues. Are you using DVI or VGA?

Give us the make and model of the system so we can look for system-specific issues.

Check out these search results from MS.
http://search.microsoft.com/Results.aspx?qsc0=0&q=Windows+XP+standby&x=10&y=4&mkt=en-US&FORM=QBME1&l=1

by jdclyde

Some of them are more system intensive than the average application.

Turn your screen saver OFF.

Just let your power saver settings turn the monitor off after a hour.

by techrepublicsucks

The computer is most likely going to Standby or Hibernate mode. This is usually indicated by your power light fading on and off on the front of the computer.

All you need to do is press the power button for a moment to get the computer running again (Don't hold it down.)

Go to your power settings in Control Panel and set to Always On and the computer should stop going to Standby/Hiberate.

I hope this helps.

by michael.umehara

Another area to check is if you are using a USB KB and/or mouse. There is a device setting buried that says to allow the device to wake the computer. Also, I have a similar issue in Vista. I can't wake the system if no one is logged in, but don't have a problem when I am logged in. Haven't traced the issue their yet...

by thanat0s

Have to change the settings in the power management...look for settings to shut hdd after a certain amout of time, think default is 20 mins, set to never, in vista, after in power management, go to advance.

Hope helps some.

Be Safe

by wshbaker9

When through for the day/evening I shut the desktop down and turn off the power/surge unit.
Starts up without problems.

This discussion is closed to new replies.