9 replies
by mustang1440 Accepted solution
by willcomp Accepted solution
by .martin. Accepted solution
check the power supply is functioning (fan turns on) and you have enough power goin to the board.
also check the fans ect. on the motherboard to see if they spin, and any light turn on.
you also did not specify if it has integrated graphics or a dedicated graphics, if it is dedicated, test it on another computer to see if it works.
by rob miners Accepted solution
require a SSI power supply (with 24-pin and 2 x 8-pin 12V plugs) EPS 12V 2.0 compliant Minimum 800W power is recommended.
If you do have an adequate power supply check the user manual for resetting the CMOS and check that there is a jumper on it. Check the manual to see if you have the memory in the right slots.
< to add >
If it is in a case backoff all of the mobo screws as it could be shorting. It is best to get them up and running on the bench before putting the mobo in a case.
Keep us informed as to your progress if you require further assistance.
If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D
by oh smeg Accepted solution
Come with the CMOS Jumper set to off to conserve the battery. When in this position generally pins 2 & 3 are shorted instead of Pins 1 & 2 the System will not start.
Knowing which M'Board is also vitally important here as some are very critical on components fitted or the way that the M'Board dis fitted. But generally speaking you need to mount the CPU Heat Sinks after you fit the M'Board and make sure that they are actually screwed into the case through the M'Board.
Also read the Manual and make sure that you are fitting the RAM Correctly as they need to be fitted to Slot 1 and so on. You also need to be sure that you are using the Correct Type or RAM which should be EEC and a Brand & Type supported by the M'Board. It may also require Matched CPU's as apposed to just grabbing 2 Identical CPU's.
Reduce it to the absolute minimum components possible that is 1 CPU 1 Stick of RAM and nothing else and try booting again. listen for any Beeps from the M'Board and tell us what is happening.
Also the Model of the M'Board is vital.
Col
by 1bn0 Accepted solution
by oh smeg Accepted solution
If it is arranged to have a Bank of RAM per CPU like the Tyan M'Boards then if you have 2 CPU's Fitted you need 2 Ram Sticks at the very least. 1 for each CPU but if you reduce the M'Board to 1 CPU adding the second RAM Stick is just a waste of time and effort as it is not being used.
However if the RAM is arranged to share the one lot between the 2 CPU's then most times you can get away with just the one stick fitted to test the function of the unit.
Of course without knowing the Make & Model of the M'Board this is all academic really. ;)
Col
by sue t Accepted solution
by orillasound Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending