Question Locked

computer wont turn on but fans do

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently shut down my computer and walked away. When I came it sounded like it was still on because the fans were running. There was a red led light on at the front. I tried to use the computer but it would not respond. I pushed the power button and reset button, neither would do anything. I flipped the master power switch off and it shut down. When I flipped the master switch on again the fans started up, the red LED light came on, a green light turned on at the bottom of the motherboard and a light turned on on my wireless card. There was however no system response or image on the monitor.

Typically if switch on the master switch I still have to press the power button to start the computer. Now, this is not the case.

Any ideas what is wrong with my computer?

7 replies

by entawanabi

Ity may take days, and at least hours for the thing to run down enough to be shut down and then much longer even with the fans running to bleed off the accumulated energies that keep everything.
Curious, Do you have a system back-up service with a copy of your memorys as these are no longer complete or unloosable?
Enta Wanabi

by dwaltz2

So am I screwed? Do I just turn my computer back on and wait for it to come back to? Or does it need repair? As for the back up, I have most of my really important stuff backed up but nothing thats very recent.

by entawanabi

Turn it back on and then click START after the cold boot is over. There should be the entry "FIND" select it and type in: "MYCOMPUTER(period)exe" and send it on its way, it should come back with thatand you then push the enter button on the 'Adding Machine face to the right of the Typewriter face of the keyboard.
Using the Directory option search for the Log-On table or Chart and log-on! then useing YOUR knowledge of YOUR operation and Profession with its computer stuff do a recovery of files, then recovery of Functions and finally a Recovery of operations. If you are moving from this to another machine; hardwire one to the other and log onto the new machine and follow the recipes of YOUR trade to migrate from to.

Enta Wanabi

by dwaltz2

That sounds all good but my computer wont actually start up. My screen shows nothing and I'm pretty sure nothing is actually working except for the cpu and power source fans. I'm just trying to figure out what part of hardware has failed.

by 1bn0

has likely failed. Possibly the memory but you would normally get some kind of BEEP error code.

You data is likely(possibly) still intact but you will need to take your machine to an experienced technician to resolve your problem.

by dwaltz2

I went in to the computer and unplugged the hard drive from the power source and replugged it in and it started running, but again nothing hppend on my screen, it just spun.

This discussion is closed to new replies.