Configure Cisco CSS 11000 Switch

I shall try to remember what I have been told....

A friend of mine has said that to start configuring the switch, you need a conole cable to connect the sitch to your PC via the serial port.

Once you have done that run a mapping to see if gets any info from the computers on your network; afte that you will need to assign manually all the IP's to each port on the switch.

Do not forget to connect your switch to the server with a serial/console cable.

Lots of luck"!

Max

I am using Hyperterminal PC-Com1 port & console cable to get into the Switch. Problem is how to add IP Addresses / Ports to the specific CSS UTP Ethernet ports ? I need to know the commands !
Akash

Help works wonders in Cisco Switches.. If you get to a point in the command line where you don't know what the next word should be hit enter it will give you a list of available commands at that point.

HTH,
Chad