Question Locked

Connect Router to Router

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello this is my first post here so excuse me if i do something wrong.

my problem is as follows:
i have a network at home (normal LAN connecting 3 PC's with a Router). i want to make my Router (Marconi, dont know specific model) connect to my friends Router/Server to use his internet/bandwidth.

Firstly, is this possible? and if it is possible would it require me to have an internet account with an ISP?

Secondly, how do i do it?

so basically i want him to be my ISP (he is registered to be an ISP but has only been able to provide internet to customers via wireless and i am out of range). as far as i can see we have to either use the routing table in my router or PPP/PPPoE.

ANY help will be much appreciated.

thank you

5 replies

by oh smeg

Now to answer your question It depends on what your Router actually is. Assuming that you need to connect to your Friends Server you'll need some medium to connect to. As Wireless is out of Range you'll need some other way to connect to his server.

Normally this is handled by some form of Modem and some form of Telco Connection. This can vary from a Dial Up connection limited to 56 KBS to Optical Fiber Cable which is considerably faster.

So the first question here is how do you intend to connect to the Server here?

If Wireless is out of range you'll also be out of range for straight Network Cable Cat 5 which can only run about 175 Meters as a max length before it needs amplification again. About the only fast way to connect is via Optical Fiber but this is horrendously expensive to run and probably not acceptable either

So I'm assuming that you are stuck with a Dial Up connection where you will need a Telephone Line at each end and a Modem at each end to allow you to dial up the server and have the server accept your connection and then send whatever over the phone lines to you.

Col

by seraphs

sorry this is my fault i havent explained it fully. we are both connected to our PSTN (line rentals and everything). in my country we only have one PSTN. the way i see it is that we are technical connected but just need to find a way through the PSTN to eachother. at the moment i have a 384kb ADSL line with an ISP, he has a 4mb line.

like you said it depends on the router and probably its capabilities. he has a CISCO router and not exactly the cheap ones (again dont know the model, sorry).

that looks about it. hope i left something out that so that there is some easy means of doing this. thx again

by 1bn0

It is possible to run two DSL modems back-to-back to provide a link between two sites.

Getting the Telco to admit they can and to provide the "Dry Copper" (basically the same as an alarm circuit) can be another matter. Although most are coming around as more people are ordering DSL servicefrom alternate(not the local phone company)providers, without dial tone as they are getting VOIP with their service or just using cell phone service.

by seraphs

how does a normal ISP get you to route through them? isnt it posible to do the same since we are both on the same PSTN?

This discussion is closed to new replies.